Tyres with 2mm of tread can pass an MOT, but only if every part of the tyre meets the legal minimum. The MOT tester does not simply look at the deepest point of the tyre. Tread is measured across the centre of the tyre and round its full circumference, so a tyre that looks healthy on the outside can still fail.
What the MOT tester measures
The MOT tester checks tread against the 1.6mm legal minimum. For cars and light vans, the minimum is 1.6mm across the central three-quarters of the tread width and around the full circumference. The DVSA inspection manual grades tread below the minimum limit as a Major defect.
Because the rule applies across the central band rather than at a single point, the tester takes readings in several places. A single worn strip inside that central zone can fail the test even where the shoulders still look healthy.
Why 2mm is a pass on the day but a warning sign
A tyre at 2mm can pass the tread check if the required grooves remain at or above 1.6mm. The RAC notes that tyre and safety experts believe the 1.6mm legal minimum is insufficient to guarantee safety, and most recommend replacing tyres at 3mm.
The MOT certificate is a snapshot on the day of the test. It does not guarantee the car stays roadworthy until the next test. If a tyre is close to the limit, replacing it before the test avoids a fail and a repeat visit.
Checklist before your MOT
- Measure tread at the centre and both shoulders of every tyre, not just one spot.
- Check all four tyres, since the 1.6mm limit applies to each one.
- Look for cuts, bulges or exposed cords, which can fail the test whatever the tread depth.
- Tyres on the same axle must be the same size and structure.
- Note any tread wear advisory from your last test on the GOV.UK MOT history service.
Checking your MOT history
You can view an MOT history for free on the GOV.UK service. The service shows test results, the mileage recorded when tested, and when the next MOT is due.
Find a tyre fitter or garage
If your tyres are near the limit, book a tyre check or replacement before your MOT is due. You can compare MOT, tyre and repair providers on GetBrent, or search for vehicle repair and MOT services in London if you are based there. You can contact a garage or workshop direct to ask whether they can check tread and fit tyres on the same visit.
GetBrent lists local garages, workshops and tyre fitters for vans, cars, trailers and plant, so you can compare options near you and contact them direct to book an MOT, a tyre fit or a tread check before the test.




